Step-by-Step

Please read complete instructions on the Instructions page prior to application.  View the TV Commercial for more Step By Step views.

	Step 1 - Cut to size. Carefully cut Quick-Tile adhesive to correct size with a utlity knife prior to application.  Note: The Quick-Tile should terminate 3/16” short of the eventual tile line in all directions.
	Step 2 - Peel and stick. Peel back approximately 2 in. of release paper from the pre-cut Quick-Tile and apply exposed adhesive to the top of the application area, checking for correct alignment at both edges. Continue with successive strips of Quick-Tile, butting any joints together carefully. Note: Quick-Tile can be applied to surface in horizontal or vertical strips, although for ease of application we recommend vertical strips.
	Step 3 - Remove film. Immediately before application of tile, remove plastic film from the top surface of the Quick-Tile. Only remove film from the areas that you are ready to adhere tiles.
	Step 4 - Apply tile. Tiles must be dust-free and dry, and are pushed on the Quick-Tile with firm thumb pressure.  Before applying firm pressure, check for correct alignment after each tile is applied and pull off immediately if the tile needs realigning. Tile spacers are always recommended to ensure correct alignment and provide support during initial bond development.  The bottom tiles should always be supported until grout is fully dried.
	Step 5 - Grout. Once tiles are satisfactorily applied, grout immediately.  In areas that might get wet, the grout line should be sealed with a sealant.  Grout should also be applied into the recess between wall and tile around the edge of the tiles area (where Quick-Tile terminates short of the tile line).
	Job Done! Please read complete instructions on the Instructions page prior to application.